215 Denny Way Ste. A El Cajon, CA 92020 (800) 824-4226 (619) 258-7303 Fax: (619) 258-7413 |
Audible Circuit Probe
Model 105 $20.00 |
The Circuit Probe produces a tone that varies with resistance,
capacitance, or voltage. May be used to check, continuity, compare circuit resistances,
check capacitors, diodes or LED's, and trace audio signals (up to 1 KHz). Will test live
circuits up to 130 VDC or AC (AC is modulated tone.) Because the probe is current limited,
it will not generate the high current surges normally produced by lamp and buzzer type
testers. The probe will not harm any circuit. 9 volt battery included. Weight: 4oz. Size:
7" x 1.2" x .9" |
|
Use to check:
Continuity AC & DC Voltages Resistors - (to 1 meg. ohm) Capacitors - (to 3000 mfd.) Diodes & Transistors Compare Circuit Resistances Safe for Semiconductors & CMOS logic (probe current limited to 500 ua.)
Resistance |
DC & AC Voltage AC RANGE- 0 to 130 volts MAX |
Capacitor POLARIZED CAPACITORS (electrolytic & tantelum) Same indications as above if connected this way. |
|||
If leads are reversed, tone will only go down to
"REF. TONE" and possibly start back up. |
|||
___________________________________________________________________________________ |
|||
TRANSISTOR TRANSISTOR GOOD-When connected as above, and a tone
slightly lower than "REF. TONE" is heard. |